Intended Treatments of Arithmetic Average in U.S. and Asian School Mathematics Textbooks

This study examined how selected U.S. and Asian mathematics curricula are designed to facilitate students' understanding of the arithmetic average. There is a consistency regarding the learning goals among these curriculum series, but the focuses are different between the Asian series and the U.S. reform series. The Asian series and the U.S. commercial series focus the arithmetic average more on conceptual and procedural understanding of the concept as a computational algorithm than on understanding the concept as a representative of a data set; however, the two U.S. reform series focus the concept more on the latter. Because of the different focuses, the Asian and the U.S. curriculum series treat the concept differently. In the Asian series, the concept is first introduced in the context of “equal‐sharing” or “per‐unit‐quantity,” and the averaging formula is formally introduced at a very early stage. In the U.S. reform series, the concept is discussed as a measure of central tendency, and after students have some intuitive ideas of the statistical aspect of the concept, the averaging algorithm is briefly introduced.     

The Iyengar Type Inequalities with Exact Estimations and the Chebyshev Central Algorithms of Integrals

In this paper, both low order and high order extensions of the Iyengar type inequality are obtained. Such extensions are the best possible in the same sense as that of the Iyengar inequality. hzrthermore, the Chebyshev central algorithms of integrals for some function classes and some related problems are also considered and investigated.     

Solid-state Electrochemistry of Gadolinium Hexacyanoferrate Modified Electrode and Electrocatalytic Properties of Gadolinium Hexacyanoferrate

A new electroactive polynuclear inorganic compound of rare earth metal, gadolinium hexacyanoferrate (GdHCF), was prepared and characterized using the techniques of FTIR spectroscopy, thermogravimetric analysis (TG), UV-Vis spectrometry, X-ray photoelectron spectroscopy (XPS), ICP atomic emission spectroscopy, and EDX. The results of ICP atomic emission spectroscopy, EDX, and TGA indicated that the prepared GdHCF sample had a stoichiometry of NaGdFe(CN)₆·12H₂O (when GdHCF was prepared in NaCl solution). The FTIR spectrum of GdHCF showed that there were two types of water molecules in the structure of GdHCF: one was the interstitial water (5 H₂O), which resulted from the association of water due to H-bonding, and the other was water coordinated with Gd (7 H₂O). The results obtained using XPS showed that the oxidation state of Fe and Gd in the GdHCF sample was +2 and +3, respectively. GdHCF was immobilized on the surface of spectroscopically pure graphite (SG) electrode forming the GdHCF/SG electrode, and the solid-state electrochemistry of the resultant electrode was studied using cyclic voltammetry. The cyclic voltammetric results indicated that the GdHCF/SG electrode exhibited a pair of well-defined and stable redox peaks with the formal potential of E^0′=(197±3) mV. The effects of the concentration of the supporting electrolyte on the electrochemical characteristics of GdHCF were studied, and the results showed that the value of E^0′ increased linearly with the activity of the cationic ion of the supporting electrolyte (lga_Na⁺), with a slope of 54.1 mV, which may become a novel method for determining the activity of Na⁺ in solution. Further experimental results indicated that GdHCF had electrocatalytic activities toward the oxidation of dopamine (DA) and ascorbic acid (AA), and the electrocatalytic current increased linearly with the concentration of DA (or AA) in the range of 1.0–10.0 mmol·L^?1 (for DA) or 0.5–20.0 mmol·L^?1 (for AA).     

二元液态金属Cu-Ni和Ag-Cu凝固过程的分子动力学模拟研究

用Quantum Sutton-Chen多体势对Ag6Cu4和CuNi液态金属凝固过程进行了分子动力学模拟研究.在冷却速率2×1012到2×1014K/s范围内,CuNi总是形成fcc晶体结构,而Ag6Cu4总是形成非晶态结构.考虑到CuNi及AgCu中原子半径之比分别为1.025和1.13,那么模拟结果证实了原子的尺寸差别是非晶态合金形成的一个主要影响因素.此外采用键对及原子多面体类型指数法对凝固过程中微观结构组态变化的分析,不但能说明二十面体结构在非晶态合金形成和稳定性中所起的关键作用,又有助于对液态金属的凝固过程、非晶态结构特征的深入理解.     

环境对MgB_2氧化过程中MgO晶须生长形状的影响

用扫描电镜研究了在 Mg B2 氧化过程中环境对 Mg O晶须生长形状的影响。仅有 Mg B2 时 ,在 80 0℃左右空气气氛中 ,可生长出纳米尺寸的 Mg O晶须。若把 Mg B2 添加到氧化铝陶瓷基体中 ,则生长成竹节状晶须。Mg O晶须生长形状的差别可能是由于氧浓度以及位错等因素造成的。     

温度对PSⅡCP4 7/D1/D2/Cytb559复合物荧光光谱特性的影响

采用激励光源为514.5 nm的分幅扫描单光子计数荧光光谱装置对经20℃、42℃和48℃不同温度处理后的反应中心复合物CP47/D₁/D₂/Cyt b559的荧光光谱特性进行了研究.经解析,获得不同温度处理后,CP47/D₁/D₂/Cyt b559复合物最大峰值未发生变化,均在682 nm,说明Chla670的能量都由Chla682接收,但损耗愈来愈小,在48℃时,损耗程度最小,而其荧光百分比未发生多大变化.振动副带～700 nm和～740 nm的中心波长都发生蓝移,在不同温度下分别为:20℃ 703 nm,749 nm;42℃ 697 nm,744 nm;48℃ 694 nm,740 nm.因此可以推测温度的升高,影响了CP47/D₁/D₂/Cyt b559色素蛋白的二级结构以及色素分子的空间位置,使最大峰值处的荧光强度逐渐降低,振动副带逐渐蓝移.42℃的温度已造成影响,48℃影响较大.     

成分和厚度的依赖

通过调整Mn的成分，系统地研究了Ni81Fe19/Ni100-xMnx双层膜的磁学性质，特别是交换偏置场(Hex)的变化.当Ni100-xMnx中Mn的原子百分比在534%到600%之间时，对于150nm的Ni81Fe19，得到了最大的交换偏置场175kA/m，同时由于Mn对Ni81Fe19层的扩散所造成的磁矩的降低小于20%；高角x射线衍射证明Ni100-xMnx的晶格常数随着Mn成分的改变而变化，Mn含量越多，其晶格常数越大；制备态Ni100-xMnx膜晶格常数与θ相NiMn膜晶格常数的接近程度与NiMn膜θ相形成的容易程度相对应.也研究了交换偏置场随着Ni１００-xMnx厚度的变化，第一次得到了当Ni100-xMnx中Mn的原子百分比为706%时，Ni81Fe19(150nm)/Ni100-xMnx(90nm)双层膜在经过240℃，5h退火后，可以有80kA/m的交换偏置场，此时铁磁层磁矩的大小几乎不变. 关键词： Ni81Fe19/Ni100-xMnx 交换偏置场     

Spectral Anomalies in the Fraunhofer Diffraction Pattern

We study the spectral characteristics theoretically and experimentally in the Fraunhofer diffraction pattern formed by the diffraction of a spatially coherent, polychromatic light through a slit. It is found that the spectrum in some diffraction directions close to the singular direction is redshifted, compared to the spectrum of the incident polychromatic light, and blueshifted in other directions, and splits into two lines at the singular direction. We show that the experimental results are consistent with the theoretical expectations.     

Sulfonated poly(aryl ether ketone)s containing naphthalene moieties obtained by direct copolymerization as novel polymers for proton exchange membranes

A series of sulfonated poly(aryl ether ketone)s (SPAEKs) were prepared by aromatic nucleophilic polycondensation of 2,6‐dihydroxynaphthalene with 5,5′‐carbonyl‐bis(2‐fluorobenzenesulfonate) and 4,4′‐difluorobenzophenone. The structure and degree of sulfonation (DS) of the SPAEKs were characterized using ¹H NMR spectroscopy. The experimentally observed DS values were close to the expected values derived from the starting material ratios. The thermal stabilities of the SPAEKs were characterized by thermogravimetric analysis, which showed that in acid and sodium salt forms they were thermally stable in air up to about 240 and 380 °C, respectively. Transparent membranes cast from the directly polymerized SPAEKs exhibited good mechanical properties in both dry and hydrated states. The dependence of water uptake and of membrane swelling on the DS at different temperatures was studied. SPAEK membranes with a DS from 0.72 to 1.60 maintained adequate mechanical properties after immersion in water at 80 °C for 24 h. The proton conductivity of SPAEK membranes with different degrees of sulfonation was measured as a function of temperature. The proton conductivity of the SPAEK films increased with increased DS, and the highest room temperature conductivity (4.2 × 10^?2 S/cm) was recorded for a SPAEK membrane with a DS of 1.60, which further increased to 1.1 × 10^?1 S/cm at 80 °C. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 2866–2876, 2004     

Synthesis and characterization of well‐defined diblock and triblock copolymers of poly(N‐isopropylacrylamide) and poly(ethylene oxide)

Well‐defined diblock and triblock copolymers composed of poly(N‐isopropylacrylamide) (PNIPAM) and poly(ethylene oxide) (PEO) were successfully synthesized through the reversible addition–fragmentation chain transfer polymerization of N‐isopropylacrylamide (NIPAM) with PEO capped with one or two dithiobenzoyl groups as a macrotransfer agent. ¹H NMR, Fourier transform infrared, and gel permeation chromatography instruments were used to characterize the block copolymers obtained. The results showed that the diblock and triblock copolymers had well‐defined structures and narrow molecular weight distributions (weight‐average molecular weight/number‐average molecular weight < 1.2), and the molecular weight of the PNIPAM block in the diblock and triblock copolymers could be controlled by the initial molar ratio of NIPAM to dithiobenzoate‐terminated PEO and the NIPAM conversion. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 4873–4881, 2004